How to Hang Outdoor String Lights

Hanging outdoor string lighting is an easy project, but does require some planning. You need the right product, the right tools and a design in mind when hanging your globe string lights. Let's walk through it.

Step 1: Measure & Prep

The first thing to do is measure for both your string lights and the cable guide wire you need for spanning across any open spaces. When measuring for the lights, be sure to take into account enough length to get to your electrical source, and with the cable guide wire, be sure to order enough to loop the cable back on itself at all mounting points (adding about 12 inches to each span should be sufficient).

Order your string lights (we have lots of options!) and cable guide wire, as well as extra cable clips — two for each span you plan to run. Then it's time to grab everything you'll need to get underway:

Your new string lights
Cable guide wire
Screw hooks
Extra cable clips
Wire cutter
Zip ties

If you're planning to hard wire your lights in lieu of plugging them into an outlet, consider our Custom Length String Lights to order the exact length needed for your space.

Step 2: Mount Screw Hooks

Start your installation by placing screw hooks at the mounting points you’ve picked on each end of the space. Be sure to mount the screw hooks to something sturdy such as under the eaves of a building, a large tree or some other solid structure. Many people hang strings in a zigzag pattern across an open space; if you're doing this, plan for each "zig" or "zag" to be a single cable connected at each end to a screw hook (cables can "share" a screw hook). In other words, while the string light can be continuously looped back and forth across an open space, it is easiest to individually cut each cable guide wire for each span.

Step 3: Connect & Tighten Cable

With the screw hooks in place, you’re ready to start hanging the cable. Connect the snap hook* on the cable guide wire to the screw hook at one end of the span.

Run the unfinished end of the cable to the other screw hook, loop it through and then loop the cable guide wire back through another cable clip. The cable clip allows you to adjust the length and tautness of the wire. After reaching the right length/tautness, you can cut off any excess wire extending from the cable clip.

how to hang string lights on covered patio

Alternatively, you could also use a turnbuckle to more easily get the tautness you want in the guide wire

If you are making a zigzag or other pattern and need to change direction at a sharper angle then the guide wire naturally bends, you can opt to stop and start your guide wire by cutting the guide wire and using additional cable clips to make the intersection

Step 4: Attach Your String Lights

After the guide wires are installed, you're ready to hang your string lights. we recommends using zip ties (ideally the same color as the string light) to attach your string lights to the cable guide wire (see Figure 5). For maximum support, use a zip tie on either side of each socket (in lieu of using the loop on the socket). Our commercial grade string lights do have mounting holes (either above or on each side of the socket), however for long-term reliability and easier installation, we suggest using zip ties.

Optionally, an extra zip tie between sockets can help add security and maintain a "clean" look to the installation. If going across multiple spans in a zigzag or other pattern, secure the cord with zip ties at the corners when changing directions. The same technique would be used whether your sockets are in-line or suspended, as shown.